![background image](http://html.mh-extra.com/html/sumec/powerg-pg18chd/powerg-pg18chd_manual_1390548017.webp)
a)
Pressing excessively on the tool will not speed up the drilling. In fact, this
excessive pressure will only serve to damage the tip of your bit, decrease the
tool performance and shorten the service life of the tool.
b)
There is a tremendous force exerted on the tool/bit at the time of hole break
through. Hold the tool firmly and exert care when the bit begins to break through
the work piece.
c)
A stuck bit can be removed simply by setting the reversing switch to reverse
rotation in order to back out. However, the tool may back out abruptly if you do
not hold it firmly.
d)
Always secure small work pieces in a vice or similar restraining device.
e)
If the tool is operated continuously until the battery pack has discharged, allow
the tool to rest for 15 minutes before proceeding with a fresh battery.
Cleaning and Maintenance
CAUTION!
Place the direction of rotation direction switch (5) into the middle position before
carrying out any tasks on the device, e.g. changing tools or maintenance, or before
transporting or storing the device. Inadvertent operation of the Power switch 3 may
result in injury.
Always pull the battery charger base(12) out of the mains socket and remove the
battery pack (8) before you clean or maintain the device.
The cordless Drill/Screwdriver is maintenance-free.
1) Always keep the device clean, dry and free of oil or grease.
2) Clean the device immediately after you have finished using it
3) Do not allow any liquids to enter the device. Use a cloth to clean the
housing.
4) Never use petrol, solvents or cleaning agents that might attack
plastic.
5) Store the tools, instruction manual and where necessary the
accessories in the original packaging. That way you will always have
all the information and parts ready to hand.
Summary of Contents for PowerG PG18CHD
Page 2: ...A B C ...
Page 22: ...Cordless Hammer Drill PG18CHD ...