First, rotate the torque selection bezel (4)to set the torque.
Place the point of the driver bit in the screw head and apply pressure to the tool.
Start the tool slowly and then increase the speed gradually. Release the power
switch (3) as soon as the clutch cuts in.
CAUTION:
Make sure that the driver bit is inserted straight in the screw head, or the screw
and/or bit may be damaged.
When driving wood screws, predrill pilot holes to make driving easier and to
prevent splitting of the work piece.
If the tool is operated continuously until the battery pack has discharged, allow
the tool to rest for 15 minutes before proceeding with a fresh battery.
Drilling operation
Turn the torque selection bezel (4) until the arrow aims at
symbol .
Drilling in wood
When drilling in wood, the best results are obtained with wood drills equipped with a
guide screw. The guide screw makes drilling easier by pulling the bit into the work
piece.
Drilling in metal
To prevent the bit from slipping when starting a hole, make an indentation with a
center-punch and hammer at the point to be drilled. Place the point of the bit in the
indentation and start drilling. Use a cutting lubricant when drilling metals. The
exceptions are iron and brass which should be drilled dry.
Impact drilling
Set the torque selection bezel
position of “Impact drilling” symbol
. In the
“Impact drilling” position, the safety clutch is deactivated and the maximum power is
available.
CAUTION:
Summary of Contents for PowerG PG18CHD
Page 2: ...A B C ...
Page 22: ...Cordless Hammer Drill PG18CHD ...