To stop the appliance, release the Power switch (3).
Reversing the Rotational Direction
16. This tool has a reversing switch to change the direction of rotation. Press the
rotational direction switch (5) from one side to another to switch from clockwise
rotation to counterclockwise rotation.
When the rotational direction switch (5) is in the central position, the power switch
(3) is locked and cannot be activated.
Setting the Torque
The torque can be adjusted 16 steps by turning the adjusting ring so that its
graduations are aligned with the pointer on the tool body.
The clutch will slip at various torque levels when set at the numbers 1 to 16 for
screwdriving with the minimum being position 1 and maximum when set at 16, the
and
symbols indicate drilling and hammer functionality..
Before actual operation, drive a trial screw into your material or a piece of duplicate
material to determine required torque setting
Gear Selection, Mechanical
Actuate the gear selector only when the machine is at a standstill. Two speed ranges
can be preselected with the gear selector (9).
Gear I:Low speed range; for screwdriving or working with large drilling diameter.
Gear II:High speed range; for working with small drilling diameter.
If the gear selector (9) cannot be fully engaged, lightly rotate the drive spindle with
the drill bit by twisting the drill chuck.
Operating Instructions
Apply the power tool to the screw only when it is switched off. Rotating tool
inserts can slip off.
Screw driving operation
For continuous operation, squeeze on the Power switch (3) and keep it pressed.
The harder the power switch is pressed down, the faster the speed will be.
Switching off:
Summary of Contents for PowerG PG18CHD
Page 2: ...A B C ...
Page 22: ...Cordless Hammer Drill PG18CHD ...