Sulky Polyvrac XT 100 VISION, Technician'S Operating Manual, Page: 60 / 109

XT - VISION
D
ISK ROTATION SENSOR
B8
N
AME
: T
RAINING DEPARTMENT
D
ATE
: 04/2018 P
AGE
: 60/109
REFERENCE: TECHNICIAN’S OPERATING MANUAL POLYVRAC XT VISION I
ND
02
Disk rate sensor : Inductive sensor
Spare parts references:

Sensor: 51520150
The inductive sensors produce a magnetic field at the end of their
detection head. When a metal object enters it, it disrupts this
magnetic field. This interference is exploited by an amplifier which
delivers an output signal.
Sensor adjustment:
The end of the sensor must be between 2 mm and 4 mm from the
auger head passage. When the circuit is under voltage, a light
comes on when the metal pin is detected.
Connections:
DPB connection unit:
Configuration on the console:
Start the console in granulated disks or wet bulk mode.
Access the
SETUP
menu by pressing
Sélectionner
1.Sensor configuration
Enter the PIN code 1936 and validate
Press
4. Disk setup
Enter the values in the corresponding mode:
G
RANULES MODE
W
ET BULK MODE
DISK PPR
1.00 1.00
LOW RPM 480 300
HIGH RPM 580 450
Switch the console off then start again with the second mode.
Checking the sensor:

Measure the voltage in the connection unit between the black wire and blue
wire terminals.
Vs = 0 V + light on if a metal target present
Vs = 12 V + light off if no target