OPERATING MANUAL FOR SELECT EDI 60
L300180 Iss:A
8
Warning
The unit is not for use in explosive of oxygen rich atmospheres.
The unit is for indoor use only and must not be washed down.
The unit must not be allowed to freeze or be stored at temperatures below 5ºC.
Always operate in a well ventilated area and ensure the cooling vents are not covered.
DO NOT sit on the unit, place items on top of it, or use it as a step.
Always operate the unit on a firm and level surface.
DO NOT drink the purified water produced by the unit/system. It should only be used
for the purposes intended to provide purified water for laboratory use.
If the unit develops a water leak follow the procedure in Section 4.4, DO NOT continue
to operate the equipment.
Always isolate the mains electrical power supply before working on the unit.
If the unit’s performance becomes impaired and any remedial work appears to be
outside the scope of this manual, do not operate the unit and seek advice from SUEZ.
The unit must only be serviced and maintained by SUEZ Service personnel or SUEZ
approved and trained technicians.
Failure to observe the instructions contained in this manual may compromise the
safety, performance and reliability of the unit and may void any warranties.
Under no circumstances try to service or repair the system yourself if you have not
been trained and approved to do so.
4.4
Operating staff
Only persons who have read and understood this Operating Manual
should be permitted to operate the unit. When operating the units, it is
important to observe all safety information.
Bringing the system to an immediate stop in the event of an emergency
•
Press “STOP” on the display two times, (Fast stop).
•
Turn off the electrical supply.
•
Shut off the water supply.
After remedying the damage and checking that it is safe to use:-
•
Open the water supply.
•
Turn on the electrical supply.
•
Restart the unit via the main display.
4.5
Safety information for maintenance tasks
The operator must take care to ensure that all maintenance, inspection
and assembly tasks are performed by authorised and qualified personnel
who have been sufficiently trained regarding the task at hand (via use of
Operating Manual).
