Subaru 2011 Tribeca, Owner'S Manual

Page: 204 / 580

Black plate (47,1)
北 米
Model "A3160BE-C" EDITED: 2010/ 11/ 19
Driver
’
s warning light
Front passenger
’
s warning light
!
Operation
If the driver and/or front passenger have/
has not yet fastened the seatbelt(s) when
the ignition switch is turned to the
“
ON
”
position, the seatbelt warning light(s) will
flash for 6 seconds, to warn that the
seatbelt(s) is/are unfastened. If the dri-
ver
’
s seatbelt is not fastened, a chime will
also sound simultaneously.
NOTE
.
If the driver
’
s and/or front passen-
ger
’
s seatbelt(s) is/are still not fastened
6 seconds later, the seatbelt warning
device operates as follows according
to the vehicle speed.
.
At speeds lower than approxi-
mately 9 mph (15 km/h)
The warning light(s) for unfastened
seatbelt(s) will alternate between
steady illumination and flashing at
15-second intervals. The chime will
not sound.
.
At speeds higher than approxi-
mately 9 mph (15 km/h)
The warning light(s) for unfastened
seatbelt(s) will alternate between
flashing and steady illumination at
15-second intervals and the chime
will sound while the warning light(s)
is/are flashing.
.
It is possible to cancel the warning
operation that follows the 6-second
warning after turning ON the ignition
switch. When the ignition switch is
turned ON next time, however, the
complete sequence of the warning
operation resumes. For further details
about canceling the warning operation,
please contact your SUBARU dealer.
If there is no passenger on the front
passenger
’
s seat, the seatbelt warning
device for the front passenger
’
s seat will
be deactivated. The front passenger
’
s
occupant detection system monitors
whether or not there is a passenger on
the front passenger
’
s seat.
Observe the following precautions. Failure
to do so may prevent the device from
functioning correctly or cause the device
to fail.
.
Do not install any accessory such as a
table or TV onto the seatback.
.
Do not store a heavy load in the
seatback pocket.
.
Do not allow the second-row seat
occupant to place his/her hands or legs
on the front passenger
’
s seatback, or
allow him/her to pull the seatback.
If the seatbelt warning device for the front
passenger
’
s seat does not function cor-
rectly (e.g., it is activated even when the
front passenger
’
s seat is empty or it is
deactivated even when the front passen-
ger has not fastened his/her seatbelt),
take the following actions.
Seat, seatbelt and SRS airbags
1-19
–
CONTINUED
–
1