Subaru 2011 Tribeca, Owner'S Manual

Page: 507 / 580

Black plate (354,1)
北 米
Model "A3160BE-C" EDITED: 2010/ 11/ 19
11-18
Maintenance and service
power steering fluid touches the
exhaust pipe, it may cause a bad
smell, smoke, and/or a fire. If
power steering fluid gets on the
exhaust pipe, be sure to wipe it
off.
The power steering fluid expands greatly
as its temperature rises; the fluid level
differs according to fluid temperature.
Therefore, the reservoir tank has two
different checking ranges for hot and cold
fluids.
Check the power steering fluid level
monthly.
1. Park the vehicle on a level surface,
and stop the engine.
2. Check the fluid level of the reservoir
tank.
When the fluid is hot after the vehicle has
been run: Check that the oil level is
between
“
HOT MIN
”
and
“
HOT MAX
”
on
the surface of the reservoir tank.
When the fluid is cool before the vehicle is
run: Check that the oil level is between
“
COLD MIN
”
and
“
COLD MAX
”
on the
surface of the reservoir tank.
3. If the fluid level is lower than the
applicable
“
MIN
”
line, add the recom-
mended fluid as necessary to bring the
level between the
“
MIN
”
and
“
MAX
”
line.
If the fluid level is extreme low, it may
indicate possible leakage. Consult your
SUBARU dealer for inspection.
&
Recommended fluid
Refer to
“
Fluids
” F
12-7.
Brake fluid
&
Checking the fluid level
WARNING
.
Never let brake fluid contact your
eyes because brake fluid can be
harmful to your eyes. If brake
fluid gets in your eyes, immedi-
ately flush them thoroughly with
clean water. For safety, when
performing this work, wearing
eye protection is advisable.
.
Brake fluid absorbs moisture
from the air. Any absorbed moist-
ure can cause a dangerous loss
of braking performance.
.
If the vehicle requires frequent
refilling, there may be a leak. If
you suspect a problem, have the
vehicle checked at your SUBARU
dealer.
CAUTION
.
When adding brake fluid, be care-
ful not to allow any dirt into the
reservoir.
.
Never splash the brake fluid over
painted surfaces or rubber parts.