Subaru 2011 Tribeca, Owner'S Manual

Page: 19 / 580

Decrease speed
Move the control lever to “SET/
COAST,” hold until your vehicle slows
to the desired speed, and release. To
decrease the speed using the brake
pedal, press the pedal to release
cruise control temporarily. When the
speed decreases to the desired rate,
push the control lever down to the
“SET/COAST” position.
17
Getting Started
Instrument
Panel
Gauges
Personalize
Contr
ols
While
Operating
Safety / In Case
of Emergency
Additional
Information
Contr
ols
Cruise Control
• Resume
Push the control lever
up to “RES/ACC.”
• Shut Off
To quit cruise control, push the main
“CRUISE” switch again, or, when
the vehicle is stopped, turn the
ignition switch to the “ACC” or
“LOCK” position.
• Set
Push the main “CRUISE” switch
located on the end of the control
lever. The “CRUISE” indicator
light on the instrument panel will
turn on. Press the accelerator
pedal until your vehicle reaches
the desired speed. Push the
control lever downward to “SET/
COAST” and release. Ease off the
accelerator pedal. Your vehicle will
maintain the desired speed.
• Temporary Cancel
There are three ways to temporarily cancel
cruise control: depress the brake pedal;
push the control downward to “CANCEL”; or
shift the selector lever into the “N” (neutral)
position (automatic transmission).
Increase speed
Push the control lever up to the
“RES/ACC” position, hold until
your vehicle reaches the desired
speed, and release. To increase
speed using the accelerator pedal,
press the pedal until you reach the
desired speed. Push the control
lever down to the “SET/COAST”
position to set the speed.
782335_11_Tribeca_QRG_102010b.indd 17 10/20/10 3:12 PM