Sturtevant Richmont
- P/N 857285 - Issue Date 100407 - Page 5 of 14
Red Light
Color projected onto display to indicate that the current torque exceeds the maximum
torque specified for that Task. Use of the LED color scheme is selectable in the software
(active or inactive). Active in all Tasks numbered greater than “00”. Not available in “Task
00” or Record “00”.
Keypad
The keypad to the right of the display has four buttons: Clear, Select, Up and Down.
Clear
The Clear button is used to clear a reading from the tool and make that Task/Record combination
the active combination for the next torque application. Example: The operator makes an error in
tightening the fastener. The operator returns to the correct record within the task for that record,
then presses the Clear button. This clears the display of the reading and displays the target
torque, as though the operator were facing that fastener for the fi rst time. The operator may then
properly tighten the fastener and store the torque value for the retorque where the original value
was stored.
Select
The Select button is used to navigate among tasks. During normal (job loaded) operation, press
the select button once to permit navigation among the tasks currently on the tool. Use the Up and
Down buttons to navigate to the task to be performed. Press the Select button again to make that
task the active task. Note that when so doing it is necessary to use the Up and Down buttons to
navigate to the record of interest after the task has been selected.
Up
Navigate among tasks and records. Increments count of displayed task or record by one.
Down
Navigate among tasks and records. Decrements count of displayed task or record by one.
Display During Operation
Exacta® Plus
uses a liquid crystal display and a buzzer to communicate. The display content is grouped
into four categories: items displayed during startup when the power is turned on, items displayed during
PC communications, items displayed during normal operation, and items displayed when results are being
reviewed.
Items Displayed During Startup
1.
The tool series number “3000” will be displayed in the center, and “r00N” in the Task and Record
markings will be displayed for 1 - 2 seconds. “N” is the firmware revision number.
2.
The tool capacity will be displayed in the center for 1 - 2 seconds.
3.
Upon completion of the startup routine, what is displayed is dependent upon whether or not there
are tasks in the memory of the tool
If no Tasks are in memory, the following will appear on the display:
Indicator for the Peak mode will be lit.
Indicator for Target will be lit.
IN.LB Unit Of Measure will be lit.
-000.0 will be displayed as the current torque value.
00 will be displayed for the Task number.
00 will be displayed for the Record number.
If one or more Tasks are in tool memory, the following will appear on the display:
Indicator for the active mode will be lit.
The indicator for the active Unit Of Measure will be lit.
The Target torque will be the displayed torque value.
The number of tasks in memory will be displayed in the Task section.
After startup the last task and record number worked on will be displayed. If the tool memory has
been cleared, the task and record will each be “00”.
