Sturtevant Richmont
- P/N 857285 - Issue Date 100407 - Page 3 of 14
Power Switch, Serial Port and Cover
On the top of the electronics housing are the power switch and serial port for the tool. These are protected
by a rubber that can be lifted to expose them for use. The cover should be closed at all times when access
to the serial port and/or power switch is not immediately
needed.
The tool power is enabled (power On) by sliding the switch
away from the grip as shown here. Power to the tool is
disabled (power Off) by sliding the power switch towards the
grip.
The serial cable for the wrench connects to the round serial
port that is also used to hold the cover in place. The cable
should fi rst be connected to the computer (9-pin connector)
then to the tool (single-pin connector) when the tool is to communicate with the computer and software.
Display Elements
Text Indicators and Triangular Icons
There are four words of text above the LCD. Each of the words: Target, Residual, Peak, and Stored has a
triangular icon underneath it along the top of the LCD. The icons are used in conjunction with the values in
other areas of the display. Note: The display will vary slightly from the depiction here due to differences in
the fonts used.
Target
When the triangular icon beneath this is illuminated, it means that the target value for the torque
specifi cation is displayed in the main section of the display. The target
value is the midpoint between the minimum and maximum torque
specifi cation values.
Residual
When the triangular icon beneath this is illuminated, it means that the
Residual mode is the current torque measurement mode.
Peak
When the triangular icon beneath this is illuminated, it means that the Peak mode is the current torque
measurement mode.
Record
When the triangular icon beneath this is illuminated, it means that the specifi c record in the lower right-
hand corner of the display is being reviewed and the torque for that record is the torque value currently
displayed.
Unit of Measure Indicator
Available units of measure include inch-pounds, foot-pounds and Newton metres. The current unit of mea-
sure is displayed to the right of the main section of the display.
Main Section
The main section of the display is used to display a variety of information important to the current function-
ing of the tool. During normal use, the target torque or the current torque will be displayed, depending upon
whether the tool is awaiting use or actually tightening a fastener. The triangular icons and text along the top
indicate which value is being displayed.
