Sturtevant Richmont
- P/N 857285 - Issue Date 100407 - Page 2 of 14
Battery Installation
At the end of the grip is a battery cap that covers the battery compartment inside the grip. To install the
batteries:
1. Insure that the correct batteries are those to be used, and
that they are completely charged. Follow the instructions
that come with the charger to charge the batteries before
installing them.
2. The battery cap is screwed into an internal thread inside
the grip. Remove the battery cap by unscrewing it from
the grip (CCW).
3. The battery compartment will be exposed. There are two
labels inside the compartment. Install the batteries in the
locations given by the labels and maintaining the battery
orientation shown by the labels and in the photo here.
4. Reinstall the battery cap. Tighten the cap only to snug; do
not overtighten the cap.
The 3000-Series
Exacta
®
2
has a Low Battery Indicator on
the display. If the battery voltage falls below 4.1 volts, a
battery icon will appear in the upper right-hand section of the
display, the “BAD” icon will illuminate and “bAtt” will be displayed in the main display. When this occurs it
is time to replace the batteries. Wrench will continue to operate until the battery voltage drops below 4.0
volts. At that time the display will show the message “bAtt” and the ability to operate the wrench will be
lost. Readings stored prior to that point will remain in memory. The tool will remain inoperable until the
batteries have been replaced with charged batteries.
Interchangeable Heads
The 3000-Series
Exacta
®
2
digital torque wrenches of 150 foot-pound capacity and below use the S/R
dovetail system. The tools are calibrated for use with S/R Interchangeable Heads having a 1
7
/
16
” Common
Centerline. Any S/R heads with this centerline length may be used without affecting torque accuracy. If an
interchangeable head of a different centerline length is to be used, the tool must be recalibrated with that
head (or one of the same centerline length) before the tool is used.
The 400 foot-pound capacity tool is calibrated for interchangeable heads having a Common Centerline
length of 3
7
/
8
”. When used with heads having the same Common Centerline length, no recalibration is
needed. If a head with a different Common Centerline length is to be used, the tool must be recalibrated
before use with an interchangeable head of the same Common Centerline length as the one to be used.
3000-Series
Exacta
®
2
digital torque wrenches of 250 foot-pound capacity and above (except 400 ft. lb.)
use S/R slide pin ratchets. The ratchets should be disassembled and cleaned periodically. Ratchet renewal
kits having the appropriate parts for each ratchet are available.
