STUDIO DUE Control Five, User'S And Operator'S Manual

Page: 25 / 27

When the user try to edit a custom model that is already settled in the patch. This operation is not allowed
because every changes will cause problems at the programs already created.
The user is trying to realize a custom model in which the parameter is repeated several times.
When the user try to realize a custom model in which the parameter Pan/Tilt Coarse is not followed by
Pan/Tilt fine.
When the user try to realize a custom model in which the parameter Pan/Tilt Fine is not came first Pan/Tilt
coarse.
11 - TEST FUNCTIONS
Control Five has some functions that are not available during the utilization. These functions, needed for the
test of the system, can be recalled starting when switch on the controller pressing one button or a couple of
button between the ones listed here below:
0+F3 general starting
Input this function when the controller starts for the first time, with the not-volatile memory still empty. The
following operations will be done:
1) memory test
2) memory formatting
3) A/D converters test
4) Keypad
test
When the controller starts for the first time a check on the memory not-volatile has be done, so it is not
necessary to press 0+F3 buttons.
If the memory is not formatted the following message is shown:
Press YES (F1) or ENTER to enter the operation above-mentioned, press No (F3) or ESC to start the
controller without the formatting of the memory.
In this last case the user could find errors on the functioning.
0+F1 formatting memory
Cancel all the scenes
23