STUDIO DUE Control Five, User'S And Operator'S Manual

Page: 22 / 27

If you press YES (F1) button the controller will show the following request:
Pressing YES (F1) button you delete all the memory and the controller will show:
Pressing NO (F3) button you will create a new patch without clean your work (programs and steps so far
made) and the controller will show the main menu page
In case the number of the DMX channels of the new patch is bigger than 512 the error message ‘WARNING!
No DMX512 Space!
b) The CSTM (F2) button from Configuration menu allows to create 8 custom models.
This function is useful in case you don’t find the desired model in the memory of the controller
The following menu can be visualized:
-
To increase the number of the custom model to edit press + , to decrease press -.
-
When decided the number of the custom you want to edit, Press EDIT (F1) or ENTER , to leave the
function press EXIT (F3) or ESC.
The display will show:
In this default case, the model has 32 parameters and the first one is the Dimmer
- To modify the total number of the parameters press CN-1 (F2) or CN+1 (F3).
- To change the function to the Ch01 use the -/+ buttons
- To edit the second channel press the FLASH button2 and use the -/+ buttons to assign the desired
function.
- Repeat the same operation for each one of the total channels.
- When finished, press OK (F1) or ENTER to confirm the operation, press ESC to leave the
function.
After pressing OK or ENTER the controller may ask you a confirmation:
Press YES (F1) to confirm the settled of the custom model, press NO (F3) or ESC to leave the function
without any change.
At this point the controller check if there are some parameters repeated or if the PAN/TILT Coarse-Fine are
in the right position. If there are some errors the following message will appears:
‘WARNING! REPEATED PARAMS’ (with parameters repeated)
‘WARNING! Not FN after CR’ (pan/tilt coarse is not followed by pan/tilt fine)
‘WARNING! Not CR before FN’ (pan/tilt fine is not anticipate by pan/tilt coarse)
20