STUDIO DUE Control Five, User'S And Operator'S Manual

Page: 19 / 27

- Using the MUSIC mode, the scenes can work in auto mode following a musical signal presents on the jack
input in the rear of the controller.
When in the music mode, pressing the +/- buttons you can modify the electrical level of the music signal.
MANUAL/AUTO Function:
While the controller works in auto or musical mode, it is possible to modify manually the parameters of one or
more fixtures.
-
To use this function select the spots you want mode manually.
-
You can now change manually all the parameters to the chosen spots.
-
During this operation the spots not selected will continue to run in auto mode.
-
To leave the function deselect all the spots with the NONE button.
NOTE: the controller memorize two different pages of the selected spots, depending to the manual or
automatic functioning.
Pressing AUTO or MUSIC the spots selected, the ones of the first page, will be deselected and they can be
selected again pressing MAN. In this way you can avoid that passing in automatic mode the selected spots
will not consider the manual commands and will not follow the sequence of the scenes of the program..
During the automatic function the spots selected by manual mode will found the second page, and backing
to the manual mode, these spots will be substituted with the spots of the first page.
BLACK-OUT Function:
Meanwhile running a program in AUTO, MANUAL or MUSIC mode, it is possible to insert the black out
function on all the fixtures just pressing the F3 key, located below the display; all the leds will start to blink
untill you press again the F3 key and leave the black out function.
9 – CONFIGURURATION MENU
Press the ESC button to enter in the configuration of the CONTROL FIVE, the display will show the
following menu:
- Press MODE (F3) to input the Dimmer function to the sliders CHANNELS 1..16/17..32.
a) In Editor mode the sliders will work in increasing way, so that if you raise one slider the value of the
parameter will increase, meanwhile turning down it will decrease.
The position of the slider and the value of the corresponding parameter can be equal or not:
-
when not equal, the red led is on.
-
When they are equal the green led is on.
b) In Dimmer mode the sliders assign the value of the corresponding parameters. This function can be used
only when the controller is a dimmer box, in fact you can not edit a scene in dimmer mode without loosing
the original value of the parameters, taking the ones of the sliders. In dimmer mode the slider MASTER
modifies the intensity of the channels and the FLASH 1..16/17..32 button set the corresponding parameter at
100%.
UTILITY functions:
Pressing the UTIL (F1) button allows to enter the utility menus:
a) Pressing DMXI (F1) is possible to assign a starting DMX IN channel to be used to drive the controller
from another DMX-512 console, the following menu will appear:
17