... 8 ...
pict.5b
CONNECTION THE DATA LINK (DMX 512)
The connection of the DMX signal to the MiniCity250 must be made by using the signal input connectors which are located on the
system board of the fixture. (pict.5c)
The pin nomenclature of the connectors for the connection to the DMX signal is listed in the table. (pict.5a)
In order to avoid any problem in the signal transmission, it is warmly suggested to use a cable for high speed data transmission (sect.
> 2x0.25 + gnd).
If the lines have a total length over 150-200 mts it is suggested to use a signal amplifier (art. 3004 - DMX repeter amplifier).
The usage of a normal microphonic or audio cable is suggested only for lines max 100 mts long.
To ensure the IP66 rate you must connect the DMX cable inside the base. Use the given cables fixing (pict. 5c) and connect by
following the cables numbering (pict. 5c).
The external section of the cables must be included between 3 and 6.5mm.
pict.5c
pict.5a
PIN
WIRE
SIGN AL
1
SHIELD
GROUND/RETURN/OV
2
INNERCONDUCTOR
DATA COMPLEMENT ( – = INVERTED)
3
INNERCONDUCTOR
DATA TRUE ( + = NON INVERTED)
Summary of Contents for 0102
Page 16: ...15 NOTE...
