STUDIO DUE 0102, Manual

Page: 4 / 16

... 3 ...
WARNING
!
The equipment must be earthed.
IP 66 grade: to ensure the declared IP grade choose the correct
size of the cables (from 3 to 6.5mm). All the gaskets and the
glass must be keeped in full working order.
MAIN SUPPLY CONNECTION / FUSES REPLACEMENT
pic.2
pic.1a
BEFORE USING
Read all cautions and warnings to page 1 prior to install this equipment. Particularly, read the follow:
1) Disconnect power before lamp’s replacement or servicing (service personnel)
2) Do not open the lamp cover for 5 minutes after switching off
3) Wear gloves and goggles to re-lamping or to work inside the unit (service personnel)
Before connecting the equipment to the power system: make sure that the mains voltage and frequency correspond to rated values
ref pic.1).
• The MiniCity250 can be equipped for a mains voltage 230VAC, 50/60Hz; 1,7A (internal voltage selector on the head, rear cover, pict. 1a)
on request: 100-120V, 50 or 60Hz
Connect, if they are necessary, the DMX cables to use the fixture with a remote controller or in MASTER/SLAVE mode
Connect the main power cable (ref. pic. 2)
1a) Do not install the spot close to the heat sources. Do not lay the connection cable on the spot when it is warm.
1b) This unit must be positioned as to allow its ventilation. Be careful not to acclude the in-out ventilating grilles.
1c) The unit must be positioned at least 30cm from walls or other flammable surfaces.
1d) Observe minimum distance to lighted objects of 5 meters.
External surface temperature Ta 35°C:
• After 5 minutes work; Tc=65°C.
• Once the thermic balance has been obtained; Tc=100°C.
4) The protection screens, the lenses, or the ultraviolet filters must be replaced if they are visibly damaged and their effectiveness
has been reduced, for example, by cracks or deep scratches.
5) The lamp must be replaced if it has been damaged or thermally deformed.
6) Clean regularly the external heat dissipator.
7) Do not handle the fixture by taking it by the head, but always by using the special handles.
ME
NU
DO
WN
pic.1
3 PINS CONNECTOR FOR
MAIN POWER SUPPLY
N = NEUTRAL
L = LIVE
= EARTH
MINICITY250 art. 0103 MINICITY250 art. 0103
®
SN
QC
230 V ; 1,7A - 50 Hz
AC
230 V ; 1,7A - 50 Hz
AC
Do not open for 300 seconds after the switching off.
Disconnect the unit from power before replacing the lamp or servicing
CAUTION:
Very hot lamp
• EXPLOSION HAZARD •
Ta 45°C
Tc 100°C
Ta 45°C
Tc 100°C
1m
IP 66 IP 66
LAMP MSD 250W GY9.5 LAMP MSD 250W GY9.5
T5A T2A
MAIN FUSE MAIN FUSE
INSIDE
ELEC. FUSE ELEC. FUSE
240 V
230 V