6
Operating Instructions: DME04
Section III – Unit Operation
IMPORTANT
Before using the mixer, operators must read and understand this instruction
manual. Failure to observe the instructions in this manual will invalidate the
warranty.
The unit is delivered fully assembled but should be inspected for transit
damage. Any damage should be reported to STS and the equipment should
not be used.
Never allow any part of your body or anyone else’s to be put in a position
where it might cause injury. Always operate the unit in accordance with the
instructions.
Positioning the Mixer
-
Position the mixing unit in a position close to a 230V mains power point
and ensure that the doors can be opened fully for drum loading.
-
The unit is fitted with 4 screw feet. The lock nut can be tightened to lock
the feet in place.
-
Ensure that the mixing unit is level before use.
-
Plug the mains lead into a suitable 230V power supply. Ensure that the
cable is positioned away from any areas that would cause the cable
to be a trip hazard.
Loading the Drum
-
Drum handles must be removed prior to loading the drums into the
mixer.
-
Open the two doors fully at the front of the unit. Each drum can then
be individually placed on to the inside shelf of the unit before being
positioned on to the rollers.
Note. The drum orientation should align with
the yellow instruction stickers.
-
The weighted wheels will move up and out of the way as a drum is
pushed into position.
-
Once all the drums have been loaded into the unit, close the doors so
they are held by the magnetic catches. Closing the doors activates
the safety switches which allows the unit to operate.
