•
Torque wrench (ft-lb)
•
Rubber mallet
P
Prro
occe
ed
du
urre
e::
1. Raise the product to the highest height position.
2. Remove the mattress.
3. Using a T25 Torx driver, remove the button head cap screw (A) and black bumper (B) on the side where you are
replacing the siderail (Figure 23). Save the screw and bumper.
A
B
F
Fiig
gu
urre
e 2
23
3 –– S
Siid
de
erra
aiill a
asssse
em
mb
bllyy rre
ep
plla
acce
em
me
en
ntt ((X
XP
PS
S))
4. Using a slotted screwdriver, remove the outer rail bumper.
N
No
otte
e
•
Hold on to the siderail main assembly when you remove the outer rail bumper to prevent the outer rail bumper from
falling off.
•
The head end and middle siderail pivots may be loose and could fall off of the main assembly.
5. Using a 1/4" hex wrench, remove the socket head cap screws (C) that secure the siderail clamp (D) to the ratchet
assembly at the foot end of the main assembly (Figure 24). When you reinstall, use a torque wrench to torque both new
screws to 22 ± 3.3 ft-lb.
N
No
otte
e -- The siderail will be loose, so do not operate or pull on the siderail.
6. Using a 3/16" hex wrench, remove the two socket head cap screws (E) that secure the middle siderail clamp (F) to the
outer rail assembly (Figure 24).
7. Using a 3/16" hex wrench, remove the two socket head cap screws (G) that secure the top and bottom of the base/litter
interface bracket to the outer rail assembly (Figure 24).
EN
46
6506-109-002 Rev G.1
Summary of Contents for Power-PRO XT
