25
MA_VEB100-7_A4_181015_en
4.4
Changing the flat belt
C A U T I O N !
Danger of injury!
When working on the pressing unit, switch off the power to
the completemachine, disconnect the pneumatic supply
and allow the device to cool down. Otherwise there is a
danger of fingers getting crushed, scalding and electric
shock!
Loosen the screws so that the two panels (Fig. 14 (1) and (2)) can be removed.
Remove the 4 screws at the base of the press (Fig. 17 (1)).
Fig. 17
Disconnect the plug of the step motor (Fig. 18 (1)) from the circuit board.
Afterwards, the base of the press (Fig. 18 (2)) can be taken out towards the
rear.
Fig. 18
