Strobel VEB 200-2, Mechanic'S Instructions

Page: 24 / 54

20
MA_VEB200-2_A3_210511_en.doc
3.6 Feed plates
3.6.1 Setting the feed plates
A T T E N T I O N !
Switch off machine electrically!
The feed plates should tilt easily and should sit close to the stitch plate. To guarantee
a material feed free of twist, the pressure should be set to 12N on the left and to 6N
on the right side, measured at the pivot of the feed plates. Tense the tension springs
correspondingly (Setting screws on the left back side and on the right on the top side
of the material support arm).
3.6.2 Setting the feed plate lifting (Fig. 10)
When lifting the cloth support arm the feed plates are pressed downwards. Adjustable
eccentric bolt (1) in cloth support arm extension and threaded pin (2) in lever (3) serve
as limit stop. With the cloth support arm being in its utmost upper position there
should be a play of approx. 1 to 2 mm between lever and bolt to guarantee a secure
pressing of the feed plates to the stitch plate at any stitch depth regulation.
Fig. 10