Strebel 40S-70, Installation Manual

Page: 24 / 38

20
Assembly
Table for noting system settings
Aggregate test
The control has now been set up
for the existing system and is
ready for operation. The set
values can be changed at any
time in the installer settings
menu.
The set values should be noted
in the following table so that they
are available if service is
required.
Table for noting system
settings
Customer name
Street
Town/postcode
Tel. no.
Language
Boiler type
System no.
Storage tank sensor
Storage tank sensor
length in [m]
Minimum storage
tank temp.
Tsmin [

C]
Minimum boiler
temp.
TKmin [

C]
Minimum exhaust
fume temp.
TAmin [

C]
Return valve running
time [sec]
Charging valve
running time [sec]
Aggregate test
Only possible in the operating
mode 'Heating OFF'.
For safety reasons, the
aggregate test may only be
carried out when there is no fuel
in the boiler.
The following appears on the
text display:
Heating
OFF
The selection menu is entered
by pressing the 'Arrow' button
and the following appears on the
display:
S E L E C T I O N + -
INFORMATION <--
By pressing t
he ‘Plus’ button, the
menu item
S E L E C T I O N + -
SETTINGS <--
Is selected. The selection menu
is abandoned automatically if no
button is pressed for more than
30 seconds.
By further pressing of the ‘Plus’
button, the following appears on
the display
S E L E C T I O N + -
AGGREGATE TEST
<--
The test run is activated by
pressing the ‘Arrow’ button and
the function of the aggregates
can be tested.
The displayed function or
displayed unit is
switched on by
pressing the ‘Plus’ button.
The displayed aggregate is
switched off by pressing the
‘Minus’ button.
One arrives at the
next test
step
by pressing the ‘Arrow’
button.
The
test run can be ended
prematurely by pressing the
‘Plus’ and ‘Minus’ buttons
simultaneously.
The displays, functions and
aggregates to be tested can be
seen in the ‘Short operating
instructions for the lambda
control’.