16
L/H Barge Cap
R/H Barge Cap
Coloured 10x25 self-drilling
screw with neo washer
220mm
Figure 5.22
The ends of each Barge Cap must align with the ends of the roof sheets.
Fasten two coloured 10x25 self-drilling screws with neo washers through
the front face of each Barge Cap into the Barge Support.
Fasten two coloured 10x25 self-drilling screws with neo washers through the
top of each Barge Cap and into the crests of the Roof Sheets (Figure 5.22).
220mm
Coloured 10x25 self-drilling
screw with neo washer
Figure 5.23
Place the remaining left & right Barge Caps over the Roof sheets at the
rear of the shed. Align the ends of each Barge Cap with the ends of the
Roof Sheets.
Fasten two coloured 10x25 self-drilling screws with neo washers through
the front face of each Barge Cap into the Wall Channel.
Fasten two coloured 10x25 self-drilling screws with neo washers through the
top of each Barge Cap and into the crests of the Roof Sheets (Figure 5.23).
Trestles / Blocks
750
mm
Lay the Wall Sheet on trestles or blocks. Mark and cut 750mm from the
end of the Wall Sheet (Figure 5.1).
Figure 5.1
Assemble the Wall Assembly as per Figure 1.3 - 1.10 of “Wall Assembly”.
Figure 5.2
Stratco Shed Windows are an optional add-on, avaliable in both Louvre and
Sliding variations. Installation methods are identical for each window type.
Windows can be installed in any Wall Assembly that contains a standard
Wall Sheet (not including Split Wall Sheets or Corner Wall Sheets).
WINDOW INSTALLATION
Stratco Louvre Window
Stratco Sliding Window
Figure 5.0
