11
Barge Support
Front Wall
Sliding Rail
10x16 self-drilling screw
Figure 4.8
Fit the Barge Support over the Sliding Rail. Fasten 10x16 self-drilling
screws through each pilot hole in the Barge Support and into the Sliding
Rail (Figure 4.8).
Runner Rail
Bottom Channel
Figure 4.9
Fit the Runner Rail over the Bottom Channel (Figure4.9).
Figure 4.10
Ensure the end of the Runner Rail is in line with the edge of the Corner
Bracket. Fasten three 10x16 self-drilling screws through pilot holes in the
Runner Rail and into the Bottom Channel (Figure 4.10).
Runner Rail
Corner Bracket
10x16 self-drilling screw
Figure 4.11
Check the walls are square. Check the diagonal measurements from
corner to corner (dashed lines, Figure 4.11). The diagonal measurements
should be equal for the walls to be square.
Masonry Anchor
Corner Bracket
Figure 4.11
Using the Corner Bracket pilot holes as a guide, drill holes in all four corners
with a 10mm masonry drill bit. Secure all four bottom Corner Brackets to
the concrete base with M8x47 Masonry Anchors.
Figure 4.12
Fasten one 10x16 self-drilling screw through each Hold Down Lug into
the Bottom Channel and Wall Sheet. Fix Hold Down Lugs to the concrete
base with M8x47 Masonry Anchors. Refer to Figure 4.13 for Hold Down
Lug spacings.
Hold Down Lug
Masonry Anchor
Self-drilling screw
Bottom Channel
Anchor Spacing
