Stratasys WaveWash 55, User Manual

Page: 13 / 24

11
Rinsing parts
After completing a cleaning cycle, the part(s) must be rinsed clean.
1. Lift the lid slightly while draining the cleaning solution into a drain.
2. Remove the lid and manually fill the carafe with hot water to cover the part(s) and rinse away
any residue.
3. Replace the lid and let parts soak in clean water for a approximately 5 minutes.
4. Lift the lid slightly while draining the rinse water.
Remove parts
1. Remove the lid completely and remove the part(s) from the carafe.
2. Let the water drain off the part(s) for a few minutes and if necessary, wash away any
remaining residue under running warm water.
3. Dry the part(s) with a clean cloth or paper towel.
Powering off
To power off the cleaning system, turn the power switch to the OFF position. No other steps are
necessary. If this is done while the system is cleaning a part, the current cycle will stop and parts
may not be completely clean.
Note:
Always observe your local city ordinances concerning the disposal of
wastewater.