MAINTENANCE AND TROUBLESHOOTING
3.4 Operation environment
▲
Height above sea level
≤
1000 M
▲
Operation temperature range -10
～
+40°C
▲
Air relative humidity is below 90 %( 20°C)
▲
Preferable site the machine some angles above the floor level, the maximum angle does not
▲
Protect the machine against heavy rain AND against direct sunshine.
▲
The content of dust, acid, corrosive gas in the surrounding air or substance cannot exceed
normal standard.
▲
Take care that there is sufficient ventilation during welding. There must be at least 30cm free
distance between the machine and wall.
3.5 Operation Notices
▲
Read Section §1 carefully before starting to use this equipment.
▲
Connect the ground wire with the machine directly.
▲
Ensure that the input is single-phase: 50/60Hz, 110V/220V ±10%.
▲
Before operation, none concerned people should not be around the working area and especially
children. Do not watch the arc in unprotected eyes.
▲ Ensu
re good ventilation of the machine to improve Duty Cycle.
▲
Turn off the engine when the operation finished for energy consumption efficiency.
▲
When power switch shuts off protectively because of failure. Don’t restart it until problem is
resolved. Otherwise, the range of problem will be extended.
▲
In case of problems, contact your local dealer if no authorized maintenance staff is available!
Socket Pin
Function
1
Not connected
2
Trigger Switch Input
3
Trigger Switch Input
4
Not connected
5
10k ohm (maximum) connection to 10k ohm remote control potentiometer
6
Zero ohm (minimum) connection to 10k ohm remote control potentiometer
7
Not connected
8
Wiper arm connection to 10k ohm remote control potentiometer
9
Not connected
exceed 15°.
57
www.strata.co.nz
ADVANCEMIG 255C
