(7) Place the Wire Spool onto the Spool Holder. Snip the wire from the spool being sure to hold
the wire to prevent rapid uncoiling. Feed the wire into the wire feeder inlet guide tube through to
the drive roller.
(8) Carefully feed the wire over the drive roller into the outlet guide tube, feed through about
150mm into the torch receptacle. Check that the drive roller size is compatible with the wire
diameter, replace the roller if necessary.
(9) Align the wire into the groove of the drive roller and close down the top roller making sure
the wire is in the groove of the bottom drive roller, lock the pressure arm into place. Apply a
medium amount of pressure to the drive roller.
(10) Remove the gas nozzle and contact tip from the torch neck.
14
www.strata.co.nz
ADVANCEMIG 255C
