(11) Pull the trigger to feed the wire through to the torch neck, release the trigger when the wire
exits the torch neck.
(12) Fit the correct sized contact tip and feed the wire through it, screw the contact tip into the
tip holder of the torch head and nip it up tightly.
(14) Carefully open the gas cylinder valve and set the required gas flow rate.
(13) Fit the gas nozzle to the torch head.
3.1.2 Operation of MIG/MAG Synergic welding method
1. Selection of the welding method:
1) In the main interface, press the MENU key to enter the function selection interface;
2) In the function selection interface, rotate L Knob to select the MIG/MAG Synergic welding
method and press the knob for confirmation in the interface shown below:
Fig. 1
15
www.strata.co.nz
ADVANCEMIG 255C
