2. Selection and setting of welding parameters:
1) In the main interface, press the MENU key to enter the welding parameter setting interface;
2) In the welding parameter setting interface, rotate L Knob to select the parameter as required
and rotate R Knob to set a value for the parameter, afterwards, press L Knob or R Knob for
confirmation as shown below:
Welding parameters
available by rotating L
Knob
Welding parameters
available by rotating
R Knob
Two/four Stroke
2T/4T
Pre-flow
0-2 S
Down Slope
0-10 S
Post Flow
0-10 S
3. Setting of welding current:
1) Press the ENTER key to enter the welding interface as shown below:
2) In the welding interface, rotate L Knob to set the welding current, and then press it for
confirmation;
4. Assemble front end parts of the TIG torch making sure they are correctly assembled, use the
correct size and type of tungsten electrode for the job, the tungsten electrode requires a sharpened
point for DC welding.
47
www.strata.co.nz
ADVANCEMIG 255C
