Page 33 /59
snengde_installation-product-SN-range v1.2 - Copyright Netasq 2015
PRESENTATION AND INSTALLATION GUIDE – SN RANGE
INSTALLATION PRECAUTIONS
Attaching the SN150 model appliance to the wall
The SN150 model can also be fastened vertically with screws and
fasteners (not provided with the appliance). The screw heads must
be narrower than 8mm in diameter and the diameter of the shank
must not exceed 4mm.
The procedure is as follows:
Place against the wall the 2 screws aligned horizontally, leaving
a space of 12cm between them and letting them protrude
slightly to take into account the thickness of the non-slip rubber
feet.
Once the screws have been drilled into the wall, you can insert
the screw heads into the indentations meant for this purpose,
then gently bring the appliance downwards in order to insert the
screws.
Connecting to the mains
The supported voltage ranges from 100V to 240V.
NOTE
You are strongly advised to connect all appliances to a UPS device. SN3000 and SN6000
models being equipped with redundant power supplies, plugging them into 2 separate mains
circuits is recommended.
NOTE
In the event of an accidental power cut, the product will automatically start up once it is
powered up again.
NOTE
For SN3000 and SN6000 models, 48V DC power supply modules may be provided separately
upon request.
For SN150, SN200 and SN300 models, insert the connector of the power adapter into the power socket on the
rear panel of the Firewall. Next, connect the adapter to an appropriate mains socket using the power cord
provided.
For SN500, SN700, SN900, SN910 and SN2000 models, insert the connector of the power cord (provided with
the product) into the power socket on the rear panel of the appliance. Next, plug the other end of the power
cord into an appropriate mains socket.
For SN3000 and SN6000 models, insert the connector of both power cords provided into both power sockets
located on the rear panel of the Firewall. Next, plug in the other ends of the power cords into appropriate
mains sockets.
IMPORTANT
For the SN6000 model, both power supply modules have to be inserted into your product before
starting the firewall. If the firewall starts up with only one module inserted, the missing module will
not be detected by administration tools. To fix this problem, switch off and unplug your firewall, then
wait for a few seconds. Insert the missing power supply module, then plug in both power cords and
restart the firewall.
