NavPad
™
Technical Manual
The content of this communication and/or document, including but not limited to images, specifications, designs, concepts and information
is confidential and is not to be used for any purpose, or disclosed to a third party without the express and written consent of
Keymat Technology Ltd., Copyright 2020. All rights reserved.
NavPad - Technical Manual Rev 2.2
www.storm-interface.com
Page 14 of 64
Using the Utility
Double Click on the Shortcut to start and it will display the form below. Connect the NavPad to a USB port.
Note: Before loading the form it initially detects the audio using the VID/PID and if found it sends a
device status message. If all successful, then all the buttons are enabled. If not, then they will all be disabled
except for “Scan” and “Exit
The utility allows you to:
View the installed firmware version and code table in use.
Select a Code Table, or create a Customised Table
Change buzzer behaviour / duration
Change Audio Jack Socket/ Keys LED brightness
Update the firmware
Reset to factory defaults
Test the keypad.
Using the Utility – Selecting a Code Table
You can select from three tables:
NavPad™ – Default Table
NavPad™ – Alternate Table
NavPad™ – Customise Table (select the codes you prefer using the Utility)
Once a table has been selected then the keypad will retain that configuration whilst it is powered up.
Once the keypad has been disconnected that configuration will be lost (unless you Save Changes)
To save the configuration in flash memory in the keypad click on “Save Changes”
Available only with
Illuminated key version