Stone Mud Buggy FB1000, Operator'S Manual

Page: 48 / 60

48
MUD BUGGY
Maintenance
ELECTRIC START OPTION
Inspect battery connections daily for cleanliness and tightness. Replace worn or frayed wires.
BATTERY
For battery replacement call Exide at 800-782-7848 for battery equal to 12V 165 CCA battery.
See Engine Specifications Section for battery requirements.
Battery vapors can explode. Keep sparks and flames away from batteries. Use a flashlight to
check battery electrolyte level. Never check battery charge by placing a metal object across
the posts. Use a voltmeter or hydrometer. Sulfuric acid in battery electrolyte is poisonous. It
is strong enough to burn skin, eat holes in clothing, and cause blindness if splashed into
eyes.
Avoid hazard by:
- Filling batteries in a well-ventilated area.
- Wearing eye protection and rubber gloves.
- Avoid breathing fumes when electrolyte is added.
- Avoid spilling or dripping electrolyte.
- Use proper jump start procedures.
If you spill acid on yourself:
- Flush your skin with water.
- Apply baking soda or lime to help neutralize the acid.
- Flush your eyes with water for 10 - 15 minutes. Get medical attention
immediately.
If acid is swallowed:
- Drink large amounts of water or milk.
- Then drink milk of magnesia, beaten eggs, or vegetable oil.
- Get medical attention immediately.
 Once a month check the battery condition. With engine off, check the battery for
12.5 volts with a voltmeter or check the specific gravity of the electrolyte fluid in
each cell.
 Check for proper electrolyte fluid level. Use distilled water when adding and run 30
minutes to mix. Clean battery, posts, and terminals. Disconnect battery cables
before charging to avoid damage to the electrical system.
 Once a month, check the charging system with the engine running at full speed for
13 - 14 volts with a voltmeter to ensure engine voltmeter readings are correct.
 Keep batteries clean by wiping them with a damp cloth. Keep all connections clean
and tight. Remove any corrosion and wash terminals with a solution of 1 part
baking soda and 4 parts water. Tighten all connections and check that the battery is
securely fastened with properly installed hold downs.