Stone Mud Buggy FB1000, Operator'S Manual

Page: 42 / 60

42
MUD BUGGY
operation
Fuel
Fill the gas tank with clean gasoline from a safety can. Consult the Engine Manual supplied
with this unit for the proper type of gasoline required.
DO NOT mix oil with gasoline.
HARDWARE
Check all hardware on equipment before starting. Consult the Torque Chart section in the
Service/Parts manual and tighten any loose hardware accordingly.
Follow the guidelines found in the SAFETY PRECAUTION section of this manual whenever
handling gasoline.
CLEANING/STORAGE
NEVER POUR OR SPRAY WATER OVER THE ENGINE.
Cleaning the Equipment
For consistent performance, long life and continued high quality use of this mud buggy,
thoroughly clean the bucket inside and out at the end of each day’s operation. To prevent
lumps of dried plaster from forming and contaminating further batches of plaster or mortar,
do not allow build up materials to form on bucket side walls.
Before cleaning, shut the engine off and disconnect the spark plug wire to prevent accidental
starting. Spray the bucket with water before the mix dries to remove any accumulations.
Dried mix should be scraped out as necessary. DO NOT beat on the bucket with a shovel,
hammer or other device to break up accumulations of dried mix, as this will dent and damage
the bucket and void the warranty.
Storage
Always store the equipment with the hydraulic cylinder contracted. This will prevent
corrosion of the cylinder shaft.
Prior to storage, perform any required repairs and maintenance. See Operator and/or Parts
Manuals.
WARNING