12
AFTER SALES SUPPORT
1300 886 649
AUS
MODEL: STR-DW12-W2 PRODUCT CODE: 10103 07/2019
Getting Started (Cont.)
Cold water connection
• The cold water supply hose is fixed to the back of the
appliance. Connect the hose to a threaded 3/4” connector.
(Fig. 2). During use, the dishwasher will heat up the water
to the required temperature. Make sure the hose is not
kinked or squashed and is fastened tightly in place.
• If you need a drain hose extension, make sure to use a
similar hose that is no longer than 4 metres, otherwise the cleaning effect of the
dishwasher could be reduced.
• If the water pipes are new or have not been used for an extended period of time, let
the water run to make sure it is clear and free of impurities. This step is necessary
to avoid the risk of the water inlet being blocked and damaging the appliance.
•
WARNING!
Always close the water tap after using the dishwasher.
Drain hose connection
• The drain hose must be connected to the drain hose connector at the back of the
dishwasher. Insert the drain hose into a drain pipe with a minimum diameter of
40mm, or let it run into a sink, making sure to avoid bending, crimping or squashing
it. The top of the hose must be less than 1000mm from the floor.
• Follow the illustration below (Fig. 3) when installing the drain hose connection
according to option (A) or (B).
Fig. 2
Fig. 3
Drain hose
NOTE:
The top of the hose
must be no higher than
1000mm.
Benchtop
• The drain hose must be correctly fitted in order to prevent water leaks. It should be
connected at a height of no more than 1m (maximum) and secured with a hose clip.
• If you need to drain any excess water from hoses and the sink is higher than 1m
from the floor, you will need to drain the excess water into a bowl or container held
underneath the pipe and lower than the sink.
