Still RX60-16, Original Instructions Manual

Page: 336 / 412

5
Operation
Decommissioning
– Check the hydraulic oil level and top up if
required.
– Apply oil or grease thinly to all untreated
moving parts.
– Grease the forklift truck.
– Lubricate the joints and controls.
– Lubricate the slide elements and guides
of the hydraulic battery carrier (variant);
see chapter entitled "Lubricating the slide
elements".
– Lubricate the catch rail of the hydraulic
battery carrier (variant); see chapter entitled
"Lubricating the catch rail".
– Lubricate the battery hood interlock.
– Lubricate the battery interlock and the
battery door; see chapter entitled "Checking
the battery interlock and battery door".
– Apply a suitable contact spray to all exposed
electrical contacts.
CAUTION
Risk of component damage!
If you remove the battery male connector when the
key switch is switched on (under load), an arc will be
produced. This can lead to erosion at the contacts,
which considerably shortens their service life.
– Switch off the key switch before the battery male
connector is disconnected.
– Do not disconnect the battery male connector
while the key switch is switched on, except in an
emergency.
– Disconnect the battery male connector.
– Check the battery condition, acid level and
acid density.
– Service the battery.
NOTE
Store only fully charged batteries.
324 170525 EN - 10/2016