Still RX60-16, Original Instructions Manual

Page: 325 / 412

Operation
5
Handling the battery
Preconditions
The following prerequisites apply when
replacing a battery with the hydraulic battery
carrier:
• The extension area must be free of obsta-
cles
• The ground must be stable, clean and even
• Fork must be laid safely on the ground
NOTE
When the battery is deeply discharged (less
than 10% capacity), it cannot be removed. In
this case, a reserve battery must be connected
or the battery in the truck must be charged.
6210_003-016
Emergency stop when moving the
battery
When working with the hydraulic battery
carrier, it may not be possible to reach the
emergency off switch. In an emergency,
disconnect the battery male connector.
CAUTION
Risk of component damage!
If you remove the battery male connector while
the key switch is switched on (under load), an arc
will be produced. This can lead to corrosion at the
contacts, which considerably shortens their service
life.
– Only disconnect the battery male connector
while the key switch is switched on in an emer-
gency.
170525 EN - 10/2016 313