FS 120, FS 120 R, FS 200, FS 250, FS 250 R
English
27
STIHL SuperCut 20-2,
STIHL AutoCut 25-2,
STIHL AutoCut 30-2,
STIHL TrimCut 31-2, STIHL FixCut 25-
2, STIHL PolyCut 20-3
N
Unscrew the mowing head
clockwise.
Adjusting Nylon Line
STIHL SuperCut
Fresh line is advanced automatically if
the remaining line is still at least 2 1/2 in.
(6 cm) long. The blade on the deflector
trims surplus line to the correct length.
STIHL AutoCut
N
Hold the rotating mowing head
above the ground – tap it on the
ground once – about 1 1/4 in (3 cm)
fresh line is advanced.
The blade on the deflector trims surplus
line to the correct length – avoid tapping
the mowing head more than once at a
time.
Line feed operates only if both lines still
have a minimum length of 1 in (2.5 cm).
All other mowing heads
Refer to the instructions supplied with
the mowing head.
To reduce the risk of injury, always shut
off the engine before adjusting the
mowing line by hand.
Replacing Nylon Line or Cutting Blades
Refer to the instructions supplied with
the mowing head.
Mounting metal cutting attachments
The skirt and lne limiting blade are not
required on the deflector for grass
cutting blades 230
-
4 (1), 230
-
8 (2) or the
brush knife (3) – see "Mounting the
Deflector".
Fit the approriate limit stop for circular
saw blades 200 (4, 5) – see "Mounting
the deflector".
Lay your brushcutter on its back with the
cutting attachment mounting face
pointing up: The cutting edges of (1) and
(3) may point in either direction. The
cutting edges of (2), (4) and (5) must
point clockwise.
Direction of rotation is indicated by an
arrow on the inside of the mowing
attachment deflector or limit stop.
N
Place the cutting attachment (6) on
the thrust plate (7).
Collar (see arrow) must engage the
mowing head's mounting hole.
N
Fit the thrust washer (8) and rider
plate (9) on the shaft (10).
N
Block the drive shaft.
N
Use the combination wrench (12) to
screw the mounting nut (11) on to
the output shaft counterclockwise
and tighten it down firmly.