FS 120, FS 120 R, FS 200, FS 250, FS 250 R
English
23
Mounting the Loop Handle without
Barrier Bar
N
Place the clamp (3) in the loop
handle (4) and position them both
against the drive tube (5).
N
Place the clamp (6) against the
drive tube.
N
Line up the holes.
N
Fit washers (7) on the screws (8)
and insert the screws in the holes.
Fit the square nuts (1) and screw
them down as far as stop.
N
Go to "Securing the Loop Handle".
Securing the Loop Handle
N
Secure the loop handle (4)
approx. 8 in (20 cm) (A) forward of
the control handle (9).
N
Line up the loop handle.
N
Tighten down the screws firmly –
lock the nuts if necessary.
The sleeve (10) (not fitted on all models)
must be between the loop handle and
the control handle.
A properly adjusted throttle cable is the
precondition for correct operation in the
full throttle, starting throttle and idle
positions.
Adjust the throttle cable only after the
unit is fully assembled – the control
handle must be in the normal operating
position.
N
Use a suitable tool to push the slide
to the end of the slot (see
illustration).
N
Press down the throttle trigger
lockout (1) and squeeze the throttle
trigger (2) (full throttle) – this sets
the throttle cable correctly.
4
5
002BA136 KN
1
6
1
3
8
7
8
7
10
9
4
002BA147 KN
A
Adjusting the Throttle Cable
002BA163 KN
STOP
249BA017 KN
1
2