![background image](http://html1.mh-extra.com/html/stihl/fc-75/fc-75_user-manual_1378585034.webp)
- Remove shroud,
•
Unhook nipple (1) on throttle
cable from slotted pin (2) on
throttle lever.
Note:
in the case of
machines with one short-circuit
wire.
•
Pull throttle cable out of ten-
sioner.
•
Unplug short-circuit wires from
sockets on ignition module.
- Remove throttle trigger,
•
Disconnect short-circuit wires
from connector lugs.
The parts are installed in reverse
order.
•
Short-circuit wires, throttle cable
and tubing for throttle cable must
be correctly routed inside the
handle moulding.
Note: The throttle lever must butt
against the stop on the carburetor
body when the throttle trigger is in
the full throttle position and
against the idle speed adjusting
screw when the trigger is in the
idle position.
The throttle cable is adjusted by
moving the tensioner.
- Remove shroud,
- Check correct setting of idle
speed adjusting screw.
Important! Note adjusting range
of idle speed adjusting screw.
- To make the adjustment, press
the throttle trigger to the full
throttle position.
•
Turn adjusting screw (1) clock-
wise until throttle lever (2) butts
against stop (3) on carburetor
body.
- Release throttle trigger (idle posi-
tion). The throttle lever must butt
against the idle speed adjusting
screw (4).
- Refit shroud.
392RA101
VA
392RA102
VA
392RA103
2
3
1
4
VA
Throttle cable with two short-circuit wires
982RA073
VA
392RA100
2
VA
1
392RA058
VA
34