Final Assembly Continued
☐
Using provided 4-40 x 3/8 in. steel machine
screws secure motor to firewall. Tip: Shim
left side of motor mount with 1/16 plywood
washers (located on sheet 18/19) for right
thrust.
☐
Mount ESC to inside edge of fuselage using
hook and loop tape (not provided).
☐
Open up hole in W6 former of wing to allow
servo wires to pass through.
☐
Remove covering over servo pockets.
☐
Prepare long servo control arm with Mini E/Z
connector (DUB845) located in second
position out from servo arm center.
☐
Trim two (2) Micro2 (DUB919) control horn
“posts” to 1/8 in. length.
© 2009 Stevens AeroModel all rights reserved.
Page 28 of 30
