Final Assembly Continued
☐
Mount Rudder and Elevator servos.
Trim
length of long single-sided servo horn,
provided with your HS-65, by one position; for
both rudder and elevator servos.
☐
Install Du-Bro RC Mini E/Z connector
provided with your pushrod kit (DUB922) to
inside hole of trimmed servo arms.
☐
Install HS-65 servos within fuselage using
hardware provided with servo.
☐
Use radio, or servo tester, to electronically
center servos. Install control horns to servos
then pass pushrods through housing from tail
of aircraft ending through E/Z connector as
illustrated below.
☐
Trim two (2) Micro2 (DUB919) control horn
“posts” to 1/8 in. length.
☐
Install control horn to laser drilled holes on
push-rod side of elevator and rudder and
bond with medium CA glue.
© 2009 Stevens AeroModel all rights reserved.
Page 26 of 30
