Finishing Cont.
☐
Fit the Horizontal Stabilizer to the fuselage,
ensuring that it is square and perpendicular,
and secure with medium CA. Install Vertical
Stabilizer in the same way.
☐
Apply tape hinge to bottom portion of Rudder
in the same manner as before.
☐
Apply a 6 in. length of 3/4 in. wide self
adhesive Velcro (not included) along F1 to
retain battery and receiver.
☐
Clip three of the four arms of the small four-
way control horn supplied with your HS-55
servos. Mount a Mini E/Z Connector
[DUB-845] to outside hole in servo arm.
☐
Electronically center servos and mount arms
perpendicular to servo. Mount servos in
fuselage with arms extending outward.
☐
Open covering over pushrod guide exits using
a length of 1/32 in. wire pushrod.
SkyBuggy © 2010 Stevens AeroModel all rights reserved.
Page 25 of 30
90 degrees
90 degrees
90 degrees
Pushrod exit
View: Bottom
View: Bottom
Velcro
Tape
