Finishing Cont.
☐
Make a 90 degree bend 1/8 in. from the end
of each 1/32 in. wire pushrod. Install
pushrods in beginner (outside) hole for test
flights, retain with an E/Z Link [DUB-849]
secured with a short piece of fuel tubing.
☐
Pass pushrods through E/Z Connectors,
center control surfaces, secure pushrods with
set screw, then trim 1/4 in. beyond connector.
☐
Connect Speed Control to motor, and pass
ESC through hole in F2. Install motor on
motor mount. Drill a 1/32 in. pilot hole
through gearbox housing motor mount stick.
☐
Secure motor with a #2 1/4 in. screw.
☐
Mount wheels on pre-bent landing gear and
secure with rubber wheel retainers. Cut off
excess wire.
☐
Mount landing gear through slot on fuselage
and retain to landing gear lug with mini black
rubber bands. Wrap rubber bands around lug
and landing gear three times.
SkyBuggy © 2010 Stevens AeroModel all rights reserved.
Page 26 of 30
Trim
View: Bottom
Silicone Tube
E/Z Link
Beginner
Advanced
Trim
Slot
Rubber Band
Gear Lug
