Wing Construction Cont.
☐
Trim leading edge stock where it extends past
W7 wing tip.
☐
With a razor plane and sanding bar, shape
leading edge to flow smoothly into W7.
☐
With a razor plane and sanding bar, shape
leading edge to match general profile given
below.
Note: It is not critical to exactly match
profile, simply remove the harsh angle
creating a more blunt / round leading edge.
☐
Bond W8 ply trailing edge reinforcement
within center notch at W2 trailing edge.
☐
Use a sanding block loaded with 600 grit
paper to lightly sand wing in preparation for
covering.
☐
Cover wing with a high quality covering film.
We r e c o m m e n d S t e v e n s A e r o M o d e l
AeroLITE.
SkyBuggy © 2010 Stevens AeroModel all rights reserved.
Page 22 of 30
W8
Round Leading Edge
Notch
R1
R1
W2
W7
