Finishing
☐
Cover your model with a light weight, high
quality material such as StevensAero AeroLite
or AeroFilm.
☐
Make pushrods from the provided .032 x 18
in. wire.
☐
Make a 90 degree bend 3/16 in. from one
end.
☐
Fit the straight end into the push rod housing
in the radio compartment.
☐
Feed the wire through, carefully puncturing
the covering at the exit point.
☐
Remove wire then re-insert from the exit
point, so that the bent end remains outside of
the model.
SkyBoy 600 © 2010 Stevens AeroModel all rights reserved.
Page 46 of 55
Bottom View
Summary of Contents for SkyBoy 600
