Hatch Continued
85.
Install parts H11. These will form the other end of the hatch cooling vents. Position these
parts so that the arrows point toward the center spine H5. The straight edge should rest
over former H9, with the concave edge pointing forward. Bond with thin CA.
The fuselage is now complete. Lightly sand the fuselage in preparation for covering then
set it aside until the Final Assembly.
Tail Surfaces
86.
Build the Vertical Stabilizer first. Dry fit the parts labeled V1, V2, V3, and V4 together over
the plan provided on “Detail Sheet 1 of 2”. Bond the parts by wicking thin CA along the
joints. Follow the sanding instructions provided on the detail sheet to round the leading
edge of the Vertical Stabilizer leaving the trailing edge square.
87.
Now build the Rudder. Follow the procedure in “Step 86” above to assemble the rudder
over “Detail Sheet 1 of 2” from parts R1, R2, R3, R4, R5, R6, and R7. Do not sand the
rudder at this time.
88.
Use the short length of 1/16 in. wire to scrape out the etched area at the base of the
left
side of the rudder where the tail gear wire will nest.
Note: The trough must be deep
enough for the 1/16 in. wire to seat fully within it and flush with the outside surface of the
rudder.
89.
Bend the tail gear wire, from the same short length of 1/16 in. wire, using sturdy needle
nose pliers. Make the first 90 degree bend “A” over the diagram “Side View” on “Detail
Sheet 1 of 2”.
90.
In the same manner, make the second 45 degree bend “B”.
91.
Rotate the wire so that the bends you just made stand perpendicular to the diagram. place
the wire over the “Front View” of the diagram provided on the “Detail Sheet 1 of 2”, and
make the third 45 degree bend “C”.
92.
Working from the same position, make the next 45 degree bend “D” over the diagram.
Build Instructions
FullHouse™ 500 Build Instructions. © 2012 Stevens AeroModel. All rights reserved.
!
Page 36
□
□ □
□ □
□ □
□ □
□ □
□ □
□ □
