5-3
Operational Test
Uncrating/Installation Instructions
P-920010-163
6.
Install detergent containers. See Figures 5-1 and 5-3.
a. To open the CIP
®
100 new detergent box, press along the
perforated line.
NOTE: Do not tear out the perforated cardboard flap.
b. Place the detergent box upside down to pull out the snap-on
closure.
c. The cardboard flap and flap must be inserted in the exterior
groove of the snap-on closure.
d. Insert the detergent box fitting in the exterior groove of the
snap-on closure.
NOTE: Fitting, as well as cardboard box and flap must be inserted
in the exterior groove.
e. Place the detergent box on the shelf. Be sure color on the box
matches color on the detergent compartment sticker.
f. Pivot the feed line connector and connect to detergent con-
tainer connector (see Figure 5-3).
g. Pivot the locking plate over the feed line connector and secure
plate into the feed line connector groove and locking pin
groove.
7.
Repeat steps a to g for CIP
®
200.
8.
Close detergent compartment door.
9.
Close unit door.
10. Press
ON/OFF
pushbutton to start the unit (see Figure 5-2). For
4 seconds, display shows:
TESTING MEMORY
PLEASE WAIT
then
STERIS CORP
COPYRIGHT (C) 2001
then
POLLING KEY
then
READY
HH:MM MM-DD-YY
Figure 5-3. Detergent Boxes
Detergent
Box
Detergent Box
Fitting
Locking
Plate
Locking Pin
Feed Line
Connector
Snap-on
Closure
WARNING – CHEMICAL BURN/EYE
INJURY HAZARD: Detergents are
caustic and can cause adverse ef-
fects to exposed tissues. Do not get
in eyes, on skin or attempt to ingest
by mouth.
• Read and follow the precautions
and instructions on the detergent
label and in the Material Safety
Data Sheet (MSDS) prior to han-
dling detergent containers or ser-
vicing detergent injection pumps.
• Wear protective clothing, gloves
and face shield whenever han-
dling detergents or servicing de-
tergent injection pumps and lines.
