3-13
Installation Instructions
Uncrating/Installation Instructions
P-920010-163
14. Fix cable under frame using remaining tie-wrap.
15. On printer, connect 25-pin null modem adaptor. Tighten screws.
For 200 Glasware Washers:
16. If unit is freestanding:
a. Remove utility connection plate from left side of optional
freestanding panel (see Figure 3-5).
b. Run printer cable through hole and connect cable connector
to 25-pin null modem adaptor. Tighten screws.
c. Plug printer to building electrical outlet.
17. If countertop unit:
a) Drill a 2-1/2" (64 mm) hole in countertop under the future
position of printer. Install countertop (see Figure 3-6).
b. Run printer cable through hole and connect cable connector
to 25-pin null modem adaptor. Tighten screws.
c. Plug printer to building electrical outlet.
NOTE: Before pulling out unit for service or maintenance purposes,
be sure to disconnect printer or to loosen printer cable to prevent
cable from breaking.
18. If unit is undercounter:
a. Drill a 2-1/2" (64 mm) hole in countertop under the future
position of printer.
b. Run printer cable through hole and connect cable connector
to 25-pin null modem adaptor. Tighten screws.
c. Plug printer to building electrical outlet.
For 250 Glassware Washers:
19. Freestanding Units:
a. Run cable from behind unit through wall until desired printer
location and connect cable connector to 25-pin null modem
adaptor. Tighten screws.
b. Plug printer to building electrical outlet.
20. If unit is recessed:
a. Run cable from behind unit through wall by the upper right
corner, between wall and barrier wall flange and connect
cable connector to 25-pin null modem adaptor. Tighten screws.
b. Plug printer to building electrical outlet.
21. For further information on printer (printer options, paper instal-
lation, etc.) refer to the Installation and Operator Manuals
provided with the printer.
CAUTION - POSSIBLE EQUIPMENT
DAMAGE: Do not cut printer cable.
The whole (105'' [2,667 mm]) length
of the printer cable is required
when pulling out the unit for ser-
vice or maintenance purposes.
