3-17
Installation Instructions
Uncrating/Installation Instructions
P-920010-163
1. Open crate, discard foam and packing material. Remove free-
standing panels and hardware kit.
2. Freestanding panels hardware kit contains:
•
8-32 x 1/4" screws (12)
•
Connection Plates (2)
3. Install freestanding panels on washer frame using provided
screws (see Figure 3-5). Be sure bottom cutout is facing down.
4. If necessary for glassware washer connections, remove utility
connection plates (see Figure 3-5).
5. Push glassware washer, and/or Purified Water Generator Sys-
tem (optional) and/or Water Softener System (optional) unit(s)
against the wall. Make sure flexible hoses behind the unit(s) are
not crushed or squeezed.
NOTE: If a glassware washer is installed between a Purified Water
Generator and a Water Softener, only two freestanding panels will
be required for the three units.
NOTE: The Reliance 200/250 Glassware Washer must always be
installed against a wall to prevent access to electrical components.
Only a qualified technician should have access to electrical compo-
nents.
1. Open crate, discard foam and packing material. Remove
countertop, rear protection panel, and hardware kit.
2. Countertop hardware kit contains:
•
Countertop
•
Rear protection Panel
•
Rubber bumpers with washers (4)
•
Nylon shoulder washers (2)
•
6-32 x 1/4" screws (5)
•
1/4 x 20 nuts (2)
•
1/4 x 1-1/4" bolts (2)
•
8-32 x 1/2" screws (3)
•
1/4 x 1-1/2" bolts (2)
•
Anchors (2)
3. Install four rubber bumpers on top of frame using 6-32 x 1/4"
screws (see Figure 3-6).
4. Latch countertop into position and check alignment with sides
and rear of unit.
5. If countertop is not properly aligned, remove countertop, loosen
screws on the brackets.
>> Optional Freestanding
Panels (200 Model)
>> Optional Countertop
(200 Model)
CAUTION - POSSIBLE EQUIPMENT
DAMAGE: Do not cut flexible hose
(utilities and draining) and/or main
supply cord. The whole (105''
[2,667 mm]) length of the flexible
hose and main supply cord is re-
quired when pulling out the unit for
service or maintenance purposes.
