Steren CCTV-965, Instruction Manual

Page: 56 / 62

Full disc you have two options: keep recording or stop recording. The selected action will be activated when the disk is full.
Camera selection: Use [↑] [↓] to select a camera.
Flow type: you can select between audio and video recording or video only.
Resolution: use it to set recording resolution. Options comes from lowest to highest.
Transfer rate: use it to set recording transfer rate.
FPS: higher FPS better image quality
Pre-recording time: use it to set the time after motion detection.
Post-recording time: use it to set the time to stop recording after motion detection.
Enable / Disable recording: use it to activate or deactivate recording for selected camera.
Time: use to select the time a camera will be activated.
You can set day, time and recording time for each camera. For recording type, the options are: motion detection, alarm and
motion and alarm.
Note: If you modify one of these options, you must restart the DVR.
Do not modify any of this parameters. Factory settings are designed to work with the DVR.
If you connect a PTZ camera in RS-485 port, you can set the parameters.
Network parameters
PTZ