SVX8004 IP PBX System User Guide
陈泽科技有限公司
- 8 -
www.stephen-tele.com
The signal tone cannot be heard from the handset before the booting process is completed. The STS light on the front panel
will flash for a few moments during boot-up, and then remain lit, indicating the device is on.
2.6.7.
Connect the PSTN line
Connect one end of the RJ-11 telephone cable to wall phone jack of an incoming phone line and the other end to the Line jack at
the back of the SVX8004 IP PBX.
WARNING!
Never connect the line to the Phone jack. Otherwise, the device may be damaged.
3.
Configuration
3.1.
Initial Configuration
3.1.1.
Get the device IP address
Pickup the phone connected on the Ext port, dial *100#, and then follow the voice instruction. Press “0” key to listen for the IP
address of the device.
NOTE:
You may not hear the voice from the phone if the device is still in booting process. The STS light on the front panel will flash
during boot-up, then remain lit, indicating the device is on.
3.1.2.
Login into the Web interface
Make sure your computer is in the same subnet with the device by modifying your computer’s IP address to match the
device’s IP address.
Start web browser, enter the IP address of the device into the address bar. The login page will appear:
Enter the user name and password to login. The default user name is “admin”, and the password is “admin”.
NOTE:
